Pneumatic pipeline emulsification pump

Pneumatic pipeline emulsification pump

Model:CHA-200

This product uses a pneumatic motor as the power, which has the characteristics of safety and explosion-proof, and no heat when overloaded. The pump cavity adopts a mechanical seal made of special nano materials, which has good lubricity and high wear resistance. At the same time, the mechanical seal adopts a cooling system that uses material solvents as the cooling liquid to prevent contaminants from materials.This machine uses three groups of specially designed high-speed rotor and stator combinations. The rotor rotates at high speed under the drive of a pneumatic motor. The centrifugal force produces a strong axial suction force to suck the material into the cavity. The material is received in the narrow gap between the rotor and the stator. Strong mechanical and hydraulic pressure shearing, centrifugal extrusion, liquid layer friction, impact tearing and turbulence, etc., ensure that the material is dispersed, sheared, and emulsified to achieve the purpose of high liquid dispersion and rapid refinement of the same body particles.The material is processed in three stages. After the material passes through the first stage, the speed energy is converted into pressure energy, and then enters the second stage, the second stage, the stator, and the third stage, the third stage, the stator, due to the sealing effect. , All materials will be subjected to the continuous action of six revolutions and stators, allowing the materials to withstand hundreds of thousands of shearing actions, and obtain a uniform and fine dispersion and emulsification effect.


Technical Parameters:

Rated power: 1.5KW-5KW

Speed: above 3000rpm

Flow rate: 2-3m3/hr

Suitable material viscosity: below 3000CPS

Inlet and outlet diameter: 1-1½"

Working pressure: 4-8bar

Air consumption: 1.5-5.5m³/min

Use air pipe: ¾"-1" (to ensure air flow, all pipes and joints are large enough)

Maximum feed size of solid material: 3mm

Maximum impact strength of solid materials: 0.5J/cm²

 

(Remarks: The flow rate depends largely on the viscosity of the material and the working conditions of the equipped system. The flow rate is based on water as the medium. Under the maximum rated working pressure and air flow rate of the air motor, the actual measured value of the feed pressure is 0.1Mpa )






Pneumatic pipeline emulsification pump
Long press to look detail
Long by picture save/share
INQUIRY

enquiry form:

  • Please enter the verification code

Inquiry Content:


You have no items to require

Add Successfully

Pneumatic pipeline emulsification pump

enquiry
INQUIRY

enquiry form:

  • Please enter the verification code

Inquiry Content:


You have no items to require

Add Successfully

Copyright (©) 2018广东某某某重力机械有限公司  备案号:桂ICP备18002245号

添加微信好友,详细了解产品
使用企业微信
“扫一扫”加入群聊
复制成功
添加微信好友,详细了解产品
我知道了